Operating KDS-7-MNGR
This section describes the following actions:
• Configuring the Network Switch on page 8.
• Using Menu Navigation Buttons on page 8.
• Operating via Ethernet on page 9.
Configuring the Network Switch
Before setting the system, make sure that your AV over IP network switch meets the following
minimum requirements:
• Jumbo Frames – On. (at least 8000 bytes).
• IGMP Snooping – On.
• IGMP Querier – On.
• IGMP Immediate/Fast Leave – On.
• Unregistered Multicast Filtering – On.
Using Menu Navigation Buttons
Connect the device to the 24V DC power adapter and connect the adapter to the mains
electricity. The ON LED lights green, and the LINK LED flashes (indicating that no streaming
activity is detected).
Use the navigation button to easily view and set basic device parameters via the Device
menu, appearing on the device LCD display , see:
• Using KDS-7-MNGR Navigation Buttons on page 9.
Use the Navigation buttons / Use the:
• Down arrow – to move to the previous configuration parameter.
• Up arrow – to move to the next configuration parameter.
• Left arrow – to return to the previous menu.
• Right arrow – to go to the next menu.
• Enter button – accept and save the change.
To Next Page
Loading...