Kramer TP-121EDID - Transmitting Via RS-232 (for Example, Using a PC); Technical Specifications; Figure 8: RS-232 PINOUT Connection; Table 7: RS-232 PINOUT Connection

KRAMER: SIMPLE CREATIVE TECHNOLOGY
Your TP-125EDID XGA / Audio / Data Line Transmitter
16
6.2 Transmitting via RS-232 (for example, using a PC)
Prepare an RS-232 cable with a 9-pin D-sub connector at one end, and a 3-pin
terminal block connector at the other end, as defined in
Table 4 and Figure 5:
Table 7: RS-232 PINOUT
Connection
Connect this PIN on
the Terminal Block
Connector:
To this PIN on the
9-pin D-sub
Connector
TxD PIN 2
RxD PIN 3
GND PIN 5
RxD
TxD
GND
PIN 5 Connected to GND
PIN 3 Connected to RxD
PIN 2 Connected to TxD
1
2
3
4
5
6
7
8
9
RS-232 Pinout
To PC ( )
9-pin D-sub
Figure 8: RS-232 PINOUT Connection
6.3 Technical Specifications
Table 8 includes the technical specifications
1
Table 8: Technical Specifications of the TP-125EDID
of the TP-125EDID
2
INPUTS: Video: 1 UXGA on an 15-pin HD connector
Audio: 1 audio ANALOG 3.5mm mini jack
OUTPUT: 1 RJ-45 OUT connector
RESOLUTION: Up to WUXGA and 1080p
S/N RATIO: VIDEO: 58dB unweighted, 68.3dB @5MHz weighted
Audio: <-80dB
CONTROL: RS-232 3-pin terminal block
RS-232 BAUD RATE: Up to 19200kbps
RS-232 MODE: Full-duplex
BANDWIDTH: Audio: 20Hz to 20kHz @0.5dB
TOTAL GAIN: Analog/analog: 0dB, analog/SPDIF: -12dBFS
COUPLING: AC
TND+N: Audio: <0.01%
POWER SOURCE: 12 VDC 60mA
DIMENSIONS: 12.1cm x 7.18cm x 2.42cm (4.76" x 2.83" x 0.95"), W, D, H
WEIGHT: 0.3kg. (0.67lbs.) approx.
ACCESSORIES: Power supply
1 Specifications are subject to change without notice
2 With 60m CAT 5 cable