WP-789T, TP-789R, TP-789Rxr – Connecting WP-789T, TP-789R, TP-789Rxr
Connecting WP-789T, TP-789R,
TP-789Rxr
Always switch off the power to each device before connecting it to your WP-789T, TP-789R,
TP-789Rxr. After connecting your WP-789T, TP-789R, TP-789Rxr, connect its power and
then switch on the power to each device.
Connecting WP-789T to TP-789R/TP-789Rxr
In this connection illustration:
• TP-789R acts as a PoE provider, providing power to WP-789T.
• A controller is used to control the video acceptor via RS-232 control extension over
HDBaseT.
• An IR remote is used to control the video source via IR control extension over HDBaseT.
For illustrative purposes, the figure below shows TP-789R, but the same connections apply to
TP-789Rxr, with the addition of an Ethernet connector.
Figure 4: Connecting WP-789T toTP-789R
To connect WP-789T, TP-789R, TP-789Rxr as illustrated in the example in (Figure 4):
1. Connect the HDMI IN Connector on the WP-789T front panel to the HDMI source
(for example, a Blu-ray player).
2. Connect the IR Terminal Block Connector on the WP-789T rear panel to the HDMI
source via an IR emitter cable.
To Next Page
Loading...
