Kramer TP-789Rxr

Kramer Electronics Ltd.
WP-789T, TP-789R, TP-789Rxr – Connecting WP-789T, TP-789R, TP-789Rxr
9
3. Connect the HDMI OUT Connector on the TP-789R/TP-789Rxr rear panel to the
HDMI acceptor (for example, a display).
4. Connect RS-232 Terminal Block Connector on the TP-789R/TP-789Rxr rear panel
to the HDMI acceptor.
5. Connect an IR sensor cable to the IR 3.5mm Mini Jack Connector on the
TP-789R/TP-789Rxr rear panel.
6. Connect an RS-232 controller (for example, SL-240C) to the RS-232 Terminal Block
Connector on the WP-789T rear panel.
7. Connect the HDBT OUT RJ-45 Connector on the WP-789T rear panel to the HDBT
IN RJ-45 Connector on the TP-789R/TP-789Rxr rear panel.
8. Connect the power adapter to the 48V DC Power Terminal Block on
TP-789R/TP-789Rxr rear panel (not shown in Figure 4) and to the mains electricity.
Connecting TP-789R/TP-789Rxr to WP-20
In this connection illustration:
• TP-789Rxr acts as a PoE provider, providing power to WP-20.
• A controller is used to control the video acceptor via RS-232 control extension over
HDBaseT and the video acceptor via Ethernet control extension over HDBaseT.
For illustrative purposes, the figure below shows TP-789Rxr, but the same connections apply
to TP-789R except for the Ethernet connection.
Figure 5: Connecting TP-789Rxr to WP-20
8
11
10
3
6
7
12