Kramer TP-789Rxr

Kramer Electronics Ltd.
WP-789T, TP-789R, TP-789Rxr – Configuring WP-789T, TP-789R, TP-789Rxr
15
Configuring WP-789T, TP-789R,
TP-789Rxr
WP-789T, TP-789R, TP-789Rxr enable you to configure IR frequency and HDBaseT range.
Configuration DIP-Switches
TP-789R and TP-789Rxr include DIP-switches that enable you to set the HDBaseT range,
and IR frequency.
All DIP-switches are set to OFF (up) by default.
Changes to DIP-switch 4 only take effect after rebooting the device. Changes to the other
DIP switches take effect immediately.
Figure 10: TP-789R/TP-789Rxr DIP-Switches
#
Feature
Dip-switch Settings
1
TP-789Rxr
HDBaseT
Range Mode
OFF – Normal HDBaseT range.
ON – HDBaseT ultra-long range (provides increased range at
a reduced bandwidth).
TP-789R
Reserved
For future use.
2
Reserved
For future use. Set to OFF (up).
3
IR Frequency
OFF – IR frequency is 38kHz.
ON – Wide-range modulated IR frequency.
Set to OFF for backward compatibility with 38kHz IR
extension.
4
FW Upgrade
OFF – Normal operation mode.
ON – FW upgrade mode (contact customer support).
When set to ON device operation is disabled.