WP-789T, TP-789R, TP-789Rxr – Connecting WP-789T, TP-789R, TP-789Rxr
Extending IR Signals
WP-789T can receive IR commands from the IR port of a controller (for example, Kramer
SL-240C). WP-789T then extends the signal to an acceptor (for example, a display) that is
connected to the IR port of the HDBaseT receiver (for example, Kramer TP-789R) via IR
emitter cable.
To extend an IR signal from a controller:
• Connect the controller IR output to the WP-789T IR terminal block as illustrated in
Figure 9.
Figure 9: Connecting IR Controller
To Next Page
Loading...
