WP-789T, TP-789R, TP-789Rxr – Connecting WP-789T, TP-789R, TP-789Rxr
Connecting TP-789R/TP-789Rxr as PoE Acceptor
In this connection illustration:
• TP-789Rxr acts as a PoE acceptor, receiving power from TP-780Txr.
• A controller is used to control the video acceptor via RS-232 control extension over
HDBaseT.
• An IR remote is used to control the video source via IR control extension over HDBaseT.
For illustrative purposes, the figure below shows TP-789Rxr, but the same connections apply
to TP-789R except for the Ethernet connection.
Figure 6: Connecting TP-789R/TP-789Rxr as PoE Acceptor
To connect the TP-789R/TP-789Rxr as illustrated in the example in Figure 6:
1. Connect the HDMI IN Connector on the TP-780Txr rear panel to the HDMI source (for
example, a Blu-ray player).
2. Connect the HDMI OUT Connector on the TP-789R/TP-789Rxr rear panel to the
HDMI acceptor (for example, a projector).
3. Do one of the following:
a. Connect the RS-232 Terminal Block Connector on the TP-789R/TP-789Rxr rear
panel to the HDMI acceptor.
b. Connect the IR 3.5mm Mini Jack Connector on the TP-789R/TP-789Rxr rear
panel to the HDMI acceptor via an IR emitter cable.
4. Connect the IR 3.5mm Mini Jack Connector on the TP-780Txr rear panel to an IR
sensor cable to for controlling the HDMI acceptor from the transmitter side.
5. Do one or both of the following:
a. Connect the RS-232 D-sub Connector on the TP-780Txr rear panel to an RS-232
controller (for example, SL-240C).
b. Connect the Ethernet RJ-45 Connector on the TP-780Txr rear panel to a LAN-
enabled to controller (for example, SL-240C).
To Next Page
Loading...
