WP-789T, TP-789R, TP-789Rxr – Configuring WP-789T, TP-789R, TP-789Rxr
Setting IR Frequency
WP-789T, TP-789R, TP-789Rxr enable you to set the IR frequency to either fixed 38kHz or
wide-range modulated frequency. Set the device to 38kHz for backward compatibility with
38kHz IR extension.
Setting TP-789R/TP-789Rxr IR Frequency
To set the TP-789R/TP-789Rxr IR Frequency:
• Set DIP-switch 3 according to the DIP-switch configuration table (see Configuration DIP-
Switches on page 15).
Setting WP-789T IR Frequency
To set the WP-789T Frequency:
• Wire the IR terminal block according the instructions above (see Connecting to WP-789T
IR Terminal Block on page 12).
Setting HDBaseT Range Mode for TP-789Rxr
TP-789Rxr enables you to set the HDBaseT range mode as either normal or ultra-long, which
provides increased range at a reduced bandwidth.
To set the TP-789Rxr HDBaseT range mode:
• Set DIP-switch 1 according to the DIP-switch configuration table (see Configuration DIP-
Switches on page 15).
Upgrading Firmware
Contact technical support to upgrade the WP-789T, TP-789R, TP-789Rxr device firmware
To Next Page
Loading...
