WP-789T, TP-789R, TP-789Rxr – Connecting WP-789T, TP-789R, TP-789Rxr
To connect TP-789R/TP-789Rxr as illustrated in the example in Figure 5:
1. Connect the HDMI source (for example, a Blu-ray player) to the HDMI IN Connector on
the WP-20 front panel.
2. Connect the HDMI OUT Connector on the TP-789R/TP-789Rxr rear panel to the
HDMI acceptor (for example, a projector).
3. Connect the RS-232 Terminal Block Connector on the TP-789R/TP-789Rxr rear
panel to the HDMI acceptor.
4. Do one or both of the following:
a. Connect the RS-232 Terminal Block Connector on the WP-20 rear panel to an RS-
232 controller (for example, SL-240C).
b. Connect the Ethernet RJ-45 Connector on the WP-20 rear panel to a LAN-enabled to
controller (for example, SL-240C).
5. Connect the HDBT OUT RJ-45 Connector on the WP-20 rear panel to the HDBT IN
RJ-45 Connector on the TP-789R/TP-789Rxr rear panel.
6. Connect a LAN-enabled device (for example, FC-7 connected to a projection screen) to
the Ethernet RJ-45 Connector on the TP-789Rxr rear panel.
7. Connect the power adapter to the 48V DC Power Terminal Block on
TP-789R/TP-789Rxr rear panel and to the mains electricity (not shown in Figure 5).
To Next Page
Loading...
