Kramer TP-789Rxr

Kramer Electronics Ltd.
WP-789T, TP-789R, TP-789Rxr – Defining WP-789T, TP-789R, TP-789Rxr HDMI Line Transmitters and
Receivers over HDBaseT
5
TP-789R
Figure 2: TP-789R
TP-789Rxr
Figure 3: TP-789Rxr
#
Feature
Function
SETUP DIP-switches
Set the operation DIP-switches.
IN LED
Lights green when an active, far-end source device input signal is
detected.
OUT LED
Lights green when an active sink (acceptor) output signal is detected on
the local HDMI output.
LINK LED
Lights green when an HDBaseT link is established with the HDBaseT
transmitter.
POE FEEDER LED
Lights green when the device is feeding PoE power to the HDBaseT
connected transmitter.
ON LED
Lights green when the device receives power either from the power
supply unit or by PoE.
HDBT IN RJ-45 Connector
Connect to the RJ-45 HDBT OUT connector on a transmitter (for
example, WP-789T, WP-20, TP-780Txr).
HDMI OUT Connector
Connect to an HDMI acceptor.
ETHERNET RJ-45 Connector
Connect to a LAN port for LAN extension to the transmitter.
IR 3.5mm Mini Jack Connector
Connect to an external infrared emitter / sensor.
RS-232 (G, Rx, Tx) 3-pin Terminal
Block
Connects to an RS-232 port for serial link extension to a transmitter.
48V DC Power Terminal Block
If TP-789R, TP-789Rxr provides PoE, connect it to the Kramer power
supply.
If it accepts PoE, no power connection is needed.
1
2
3
4
5
6
7
8
9
10
11
12