VP-551X – Operating and Controlling VP-551X
Setting Sleep Mode
VP-551X enables configuring if and when a connected display enters sleep mode using the
Auto Sync Off feature. Auto Sync Off turns off the output after a period of not detecting a valid
video signal on the input(s) until a valid input is again detected or any keypad is pressed.
To set the Auto Sync Off:
1. On the front panel press MENU. The menu appears.
2. Click ADVANCED and select Auto Sync Off.
3. Define Auto Sync Off according to the information in the following table:
To leave outputs active at all times.
To disable outputs after ~ 2 minutes of no input detection.
To disable outputs after ~ 10 seconds of no input detection.
To disable outputs ~ 0.5 seconds after detecting a loss of input signal.
Setting Switching Mode
To set the switching mode:
1. On the front panel press MENU. The menu appears.
2. Click Advanced and select Auto Switching.
3. Select the switching mode according to the information in the following table:
Scans for a valid input when no signal is found on the selected input.
Automatically switches to the last connected input and reverts back
to the last selected input after that input is lost.
Setting Ethernet Parameters
To set the Ethernet :
1. On the front panel press MENU. The menu appears.
2. Click Advanced and define the Ethernet parameters according to the information in the
following table:
Select Static IP (default) or DHCP.
Enter to change the IP address.
Enter to change the subnet mask.
Enter to change the default gateway.
Enter TCP port # (5000, by-default).
Enter UDP port # (50000, by-default).
View the current IP address.
To Next Page
Loading...
