Kramer VP-551X

Kramer Electronics Ltd.
VP-551X – Operating and Controlling VP-551X
16
Managing EDID
To manage the EDID:
1. On the front panel press MENU. The menu appears.
2. Click EDID Manage and define the EDID parameters according to the information in the
following table:
Menu Item
Function
EDID on HDMI (1 to 8)
For each HDMI input, select a built-in EDID and press enter:
Def.1080P (default), Def. 4K(3G), Def. 4K(4:2:0), Def. 4K(6G),
HDMI Output or HDBT Output.
EDID on PC
Default
Setting HDCP
To set the HDCP on the inputs and output:
1. On the front panel press MENU. The menu appears.
2. Click Advanced and define the HDCP parameters according to the information in the
following table:
Menu Item
Function
HDCP On Input
Set HDCP support on HDMI 1 to HDMI 8 inputs to ON (default) or
OFF.
Note that:
1. HDCP must be enabled (ON) in order to support HDCP
encrypted sources.
2. Sources such as Mac computers always encrypt their outputs
when detecting that the sink supports HDCP. If the content
does not require HDCP, you can prevent these sources from
encrypting by disabling (OFF) HDCP on the input.
HDCP On Output
Select Follow Output (default) or Follow Input on each output (HDMI
OUT and HDBT OUT).
Select Follow Output (recommended) for the scaler to match its HDCP
output to the HDCP setting of the HDMI/HDCP acceptor to which it is
connected.
Select Follow Input to change its HDCP output setting according to
the HDCP of the input (recommended when the HDMI/HDCP output is
connected to a splitter/switcher).