VP-551X – Using the Embedded Webpages
Adjusting the Picture
The picture parameters can be adjusted depending on the input type.
To Adjust the picture:
1. In the Navigation pane, click Output Settings. The Device Settings page appears.
2. Use the sliders under Picture to adjust contrast, brightness, colors (red, green and blue),
Hue Saturation and sharpness.
For HDMI and CV inputs all picture adjustments are available for the PC input, hue,
saturation and sharpness are disabled.
3. Open the Noise Reduction drop-down box to define noise reduction.
Figure 23: Output Settings Page – Noise Reduction
Finetuning Image
If the PC input is selected, you can fine tune the image.
To finetune the image:
1. In the Navigation pane, click Output Settings. The Output Settings page appears.
2. Click Auto Adjust to automatically adjust the image.
3. Use the sliders to adjust the phase, clock, H-Position and V-Position.
To Next Page
Loading...
