Kramer VS-84HDCPxl

VS-84HDCPxl - Operating the VS-84HDCPxl 8x4 DVI Matrix Switcher
13
13
6 Operating the VS-84HDCPxl 8x4 DVI Matrix
Switcher
This section describes how to:
 Route inputs to outputs (see Section 6.1)
 Disconnect outputs (see Section 6.2)
 Store and recall a setup (see Section 6.3)
 Changing the port switching speed (see Section 6.4)
 Set HDCP on or off (see Section 6.5)
 Acquire the EDID (see Section 6.6)
 Lock and unlock the front panel (see Section 6.7)
 Reset the Ethernet configuration to default values (see Section 6.8)
 Control the machine via the Ethernet port (see Section 6.9)
 Upgrade the Firmware (see Section 6.10)
6.1 Routing Inputs to Outputs
To route an input to an output:
 Press an OUT key, followed by an IN key to route this input to that output
To route one input to all outputs:
 Press ALL followed by an IN button. The input is routed to all outputs
6.2 Disconnecting the Outputs
To disconnect one output:
 Press the OUT button of the output to disconnect and press OFF
To disconnect all outputs at once:
 Press the ALL button and then press OFF. This disconnects all the outputs