Contents
1 Introduction 1
2 Getting Started 2
2.1 Achieving the Best Performance 2
2.2 Safety Instructions 3
2.3 Recycling Kramer Products 3
3 Overview 4
3.1 About Fast Switching 5
3.2 Defining the VS-84HDCPxl 8x4 DVI Matrix Switcher 5
3.3 Using the IR Transmitter 8
4 Installing in a Rack 9
5 Connecting the VS-84HDCPxl 10
5.1 Connecting to the VS-84HDCPxl via RS-232 11
5.2 Connecting via Ethernet 12
6 Operating the VS-84HDCPxl 8x4 DVI Matrix Switcher 13
6.1 Routing Inputs to Outputs 13
6.2 Disconnecting the Outputs 13
6.3 Storing and Recalling a Setup 14
6.4 Changing the Port Switching Speed 15
6.5 Setting HDCP to On/Off 16
6.6 Acquiring the EDID 16
6.7 Locking and Unlocking the Front Panel 19
6.8 Resetting the Ethernet Configuration to Default Values 19
6.9 Controlling Configuration via the Ethernet Port 19
6.10 Firmware Upgrade 19
7 Technical Specifications 20
8 Default Communication Parameters 21
9 Kramer Protocol 2000 22
Figures
Figure 1: VS-84HDCPxl 8x4 DVI Matrix Switcher Front Panel 6
Figure 2: VS-84HDCPxl 8x4 DVI Matrix Switcher Rear Panel 7
Figure 3: Connecting to the VS-84HDCPxl Rear Panel 11
Figure 4: SELECTOR Buttons 14
To Next Page
Loading...
