You can control the VS-84HDCPxl using the front panel buttons or remotely via:
RS-232 serial commands transmitted by a touch screen system, PC or other
serial controller
The Kramer infrared remote control transmitter
An external remote IR receiver (optional), see Section 3.3
The Ethernet port
3.1 About Fast Switching
Older display devices required a longer time between the loss of one digital signal
and the introduction of another, as well as a physical disconnection of the
interconnecting cable in order to be able to detect and adjust to the new video
attributes and parameters. Normal switching, therefore, introduced a 5V signal
disconnection along with a delay in switching. Many newer display devices,
however, are now capable of “on-the-fly” switching.
Depending on the display device in use, the VS-84HDCPxl allows for fast
switching (minor reset and the connection kept alive) and extra fast switching (no
reset and the connection kept alive). Using the fast and extra fast switching modes
allows for fraction-of-a-second switching times when using high performance
display devices or when using a scaler on the video output.
3.2 Defining the VS-84HDCPxl 8x4 DVI Matrix Switcher
This section defines the VS-84HDCPxl.
To Next Page
Loading...
