Kramer WP-5VH2

WP-5VH2 - Configuring the WP-5VH2
17
17
8 Configuring the WP-5VH2
8.1 Setting the Configuration DIP-switch
The 4-way dip-switch provides the ability to configure a number of device
functions. A switch that is down is on; a switch that is up is off. By default, all the
switches are up (off).
Figure 5: The Configuration DIP-switch
#
Feature
Function
DIP-switch
1
Manual/Auto
Switching
Selects either manual or auto
input switching
On—Manual switching
Off—Auto switching
2
Priority/Last
Connected Switching
Selects either priority or last
connected input switching
On—Priority switching
Off—Last connected switching
Default video input priority is
HDMI > Analog
3
Manual/Auto Audio
Switching
Selects either manual or auto
audio input selection
On—Manual switching
Off—Auto switching
4
Analog/HDMI Audio
Priority Switching
Selects either the analog or
the HDMI audio input as
priority
On
DIP-switch 3 On:
Analog audio input
DIP-switch 4 Off:
HDMI>Analog priority
Off
DIP-switch 3 On:
HDMI audio input
DIP-switch 4 Off:
Analog>HDMI priority
The following table describes the switching priorities defined by DIP-switches 1
and 2.
DIP-switch 2
Status
DIP-switch 1 Auto Switching
DIP-switch 1 Manual Switching
Off—Last
Connected
When two sources are connected the
last one connected gets priority
Manual video input selection
On—Priority
When two sources are connected the
active source is selected according to
the pre-defined priority
Manual video input selection