Kramer WP-5VH2

WP-5VH2 - Operating the WP-5VH2 Remotely Using the Embedded Web Pages
19
19
9 Operating the WP-5VH2 Remotely Using the
Embedded Web Pages
The WP-5VH2 can be operated remotely using the embedded Web pages. The
Web pages are accessed using a Web browser and an Ethernet connection.
Before attempting to connect:
 Ensure that your browser is supported (see Section 11)
 Ensure that JavaScript is enabled
9.1 Browsing the WP-5VH2 Web Pages
Note: In the event that a Web page does not update correctly, clear your Web
browser’s cache by pressing CTRL+F5.
To browse the WP-5VH2 Web pages:
1. Open your Internet browser.
2. Type the IP number of the device (see Section 11.1) in the Address bar of
your browser.
Note: If authentication is enabled, the following window appears (Figure 6) and
you must enter the valid username and password to access the Web pages. For
default authentication details, see Section 11.2.
Figure 6: Entering Logon Credentials
Following a successful logon, the screen shown in Figure 7 is displayed.