Kramer WP-5VH2 - Figure 10: the Device Settings Page

24
WP-5VH2 - Operating the WP-5VH2 Remotely Using the Embedded Web Pages
 Reset the device to factory default settings
Note: After making any change to the parameters on the Device Settings page,
you must power cycle the device to activate the changes.
Figure 10: The Device Settings Page
#
Item
Description
1
Information Section
Displays information regarding the device
2
DNS name
The DNS name of the device. To set a new name,
enter the new alphanumeric name and click Set. (For
restrictions regarding the name, see Section 11.2)
3
DHCP Buttons
Click ON to turn DHCP on; click OFF to turn DHCP off
4
IP address
The IP address of the device. To set a new IP address,
enter the new valid IP address and click Set
5
Mask
The network mask of the device. To set a new mask,
enter the new valid mask and click Set
6
Gateway
The network gateway for the device. To set a new
network gateway, enter the new valid gateway and
click Set