Kramer WP-5VH2

WP-5VH2 – Contents
i
Contents
1 Introduction 1
2 Getting Started 2
2.1 Achieving the Best Performance 2
2.2 Safety Instructions 2
2.3 Shielded Twisted Pair/Unshielded Twisted Pair 3
2.4 Recycling Kramer Products 3
3 Overview 4
3.1 About HDBaseT™ Technology 5
4 Defining the WP-5VH2 Wall Plate 6
5 Connecting the WP-5VH2 10
5.1 Connecting the Remote Control Switches 11
6 Principles of Operation 13
6.1 Input Selection 13
6.2 Signal Loss and Unplugged Cable Timeouts 13
6.3 Audio Signal Control 14
6.4 VGA Phase Shift 14
7 Operating the WP-5VH2 15
7.1 Selecting an Input Manually 15
7.2 Locking the EDID 15
7.3 Resetting the WP-5VH2 15
7.4 Analog Audio Output Volume Control 15
8 Configuring the WP-5VH2 17
8.1 Setting the Configuration DIP-switch 17
8.2 Video Switching Timeouts 18
9 Operating the WP-5VH2 Remotely Using the Embedded Web Pages 19
9.1 Browsing the WP-5VH2 Web Pages 19
9.2 The Switching Page 23
9.3 The Device Settings Page 23
9.4 The Video and Audio Settings Page 26
9.5 The Authentication Page 27
9.6 The EDID Page 28
9.7 The About Us Page 30
10 Wiring the Twisted Pair RJ-45 Connectors 31
11 Technical Specifications 32
11.1 Default IP Parameters 33
11.2 Default Logon Credentials 33
11.3 Supported Resolutions 33
12 Default EDID 35
12.1 HDMI 35
12.2 PC-UXGA 37
13 Protocol 3000 39
13.1 Kramer Protocol 3000 Syntax 39
13.2 Kramer Protocol 3000 Commands 42