Kramer WP-5VH2 - Kramer Protocol 3000 Commands

42
WP-5VH2 - Protocol 3000
13.2 Kramer Protocol 3000 Commands
The following table lists the Protocol 3000 commands that the WP-5VH2 supports.
For a full description of the commands, see the Kramer Protocol 3000 document
available from http://www.kramerelectronics.com.
Note: The WP-5VH2 can only receive commands from a device, (for example, an
HDBT transmitter) via the HDBaseT link, and only at 9600bps.
Command
Description
#
Protocol handshaking
AUD-EMB?
Get audio in video embedding status
AUD-LVL
Set/get audio level in specific amplifier stage
AUD-SIGNAL?
Get audio input signal status
AV-SW-MODE?
Get auto-switch mode
AV-SW-TIMEOUT
Set/get video auto-switch timeout
BUILD-DATE?
Read device build date
CPEDID
Copy EDID data from the output to the input
DEL
Delete user file
DIR
List files in device
DISPLAY?
Get output HPD status
ETH-PORT
Set/get Ethernet port protocol
FACTORY
Reset to factory default configuration
FCT-MAC
Set MAC address
FCT-MODEL
Set model name
FCT-SN
Set serial number
FORMAT
Format file system
FPGA-VER?
Get current FPGA version
FS-FREE?
Get file system free space
GEDID
Read EDID data
GET
Get file
HDCP-MOD
Set/get HDCP mode
HDCP-STAT?
Get HDCP signal status
HELP
Get command list
LDEDID
Write EDID data to input
LDFW
Load new firmware
LOAD
Load new Transwitch firmware
LOCK-EDID
Lock last read EDID
LOGIN
Set/get protocol permission
LOGOUT
Cancel current permission level
MODEL?
Read device model