Kreg ADAPTIVE CUTTING SYSTEM - Setup: Trim Anti-Chip Strip

SETUP
Trim the Anti-Chip Strip
(1)Loosenthecut-depthstopknob,slidethe
 stoptoalignthepointerwiththe¼”mark,
 andtightentheknob.
(4) Set the blade mode to Cut.
1
(2)Placetheguidetrackonascrap
 workpieceatleast62”[158cm]longand
 1”[25mm]widerthantheguidetrack.
 Positionthesawontheguidetrackwith
 bothtrackingcontrollersengaged.
(3)Loosenthesplinterguardscrewwiththe
small hex wrench stored in the forward
 gripandraiseittothefull-upposition.
2
3
4