Kreg ADAPTIVE CUTTING SYSTEM - Maintenance and Inspections; Cleaning and Lubrication; Motor Brush Replacement; Periodic Component Inspections

USING THE SAW
+47° override
(1)Loosenthebevellocks.
(2)Tiltthesawto45°.
(3)Pushdown47ºoverridebutton.
(4)Tiltthesawto47º.
(5)Tightenthebevellocks.
1
3
MAINTENANCE
Periodic inspections
Lubrication
Thistoolcomeslubricatedforthelifeof
theunitfromthefactory.Undernormal
operatingconditions,nofurther
lubrication is necessary.
Topreventdamagetothemotor,thissaw
features a brush system that automatically
stops the saw when the brushes wear out.
Tohavethebrushesreplaced,contact
KregCustomerService.
Blow dirt and dust out of all air vents,
airintakes,andbladehousingwith
compressed air at least once a week.
Never use solvents or other harsh
chemicalsforcleaningthenon-metallic
partsofthetool.Useaclothdampened
only with water and mild soap. Never
letanyliquidgetinsidethetool.Never
immerseanypartofthetoolinaliquid.
Periodicallyinspecttheoperationoftheplungereturn.Ifthesaw
returnsslowlyorifthebladefailstofullyretract,theplungereturn
assemblycouldbedamaged.Donotattempttorepair.
ContactKregCustomerServiceforrepairs.
Periodicallyinspecttheoperationoftheanti-kickbackcontrol
duringnormaloperationandcheckaftereveryinstanceof
kickback.Inspecttheanti-kickbackcomponentsforvisibledamage.
Placethesawonthetrackwiththeanti-kickbackcontrolengaged
and pull back on the saw to verify that the saw does not move
backward.Donotattempttorepairtheanti-kickbackcontrol.
ContactKregCustomerServiceforrepairs.
Periodicallyinspecttheoperationoftherivingknife.
Therivingknifeshouldmovefreelywhileplungingthesaw.
Verifythattherivingknifeiscenteredwithinthewidthofthe
bladeteeth.Inspecttherivingknifeforbends,dents,ordamage.
Donotattempttorepairorremovetherivingknife.
ContactKregCustomerServiceforrepairs.
Periodicallyinspectthepowercordandplugforknicks,cuts,
orotherdamage.Donotattempttorepairthecordorplug.
ContactKregCustomerServiceforrepairs.
Periodically inspect the operation of the switch and switch
interlock.Verifythatbothautomaticallyreturntotheo󰀨position
when released. Do not use the saw if either the switch or switch
interlockismalfunctioning.Donotattempttorepairtheswitchor
switchinterlock.ContactKregCustomerServiceforrepairs.
WARNING:
!
To reduce the risk of injury, disconnect the plug from the power source before performing any maintenance, adjustments, or when making repairs.
Cleaning
Motor Brushes
ATTENTION
!
To maintain product safety and reliability, and
to guarantee the use of genuine Kreg replacement parts, all repairs
and any maintenance or adjustment not covered in this manual
must be performed by Kreg Tool Company.
2