Kreg ADAPTIVE CUTTING SYSTEM - Page 16

SETUP
(4)Plungethesawuntilitstopsandrelease
 theswitchinterlock.Thesawremainsin
this position.
(5) Press and hold the arbor lock and rotate
 thebladeuntilthelockengages. 
Continue to hold the arbor lock.
(6)Usingthelargehexwrenchstoredinthe
 forwardgrip,removethearborscrewand
 angewasher.
(7) Remove the blade, install a replacement,
 andreplaceandtightentheange 
washer and arbor screw.
(8) Press and hold the switch interlock
and push down on the saw to release
 theplungelock.
(9) Release downward pressure and return
 thesawtofull-upposition.
(10)Returntheblade-modeselectortothe
Cut mode.
ATTENTION
!
The arbor screw has left-hand threads. Turn it
clockwise to loosen.
ATTENTION
!
Install the blade with the teeth oriented for clockwise
rotation when viewed from the blade-side of the saw. Tooth orientation
must match the blade-rotation indicator arrow on the saw
4
9
5
4
8
6
6
7
Tighten Loosen
10
5