Rev. Date: 12/27/17 Page 36
MODEL #1300/2300
PARTS LIST
The manufacturer recommends that all repairs be made at its own factory service center. Machine repair done
by the manufacturer is warranted for 90 days on repair parts and workmanship.
If you choose to have repairs made elsewhere, we offer replacement parts that have been carefully inspected to
insure they meet the specifications of the original part. Any disassembly and reassembly of the unit to replace
the defective part must be done with care to insure proper fit and alignment. No warranty consideration will be
extended on parts that appear to be mishandled. All units should be run for a few minutes without material to insure
proper alignment. All questions regarding replacement of parts should be directed back to the factory.
IMPORTANT: Certain information is needed concerning your specific machine when ordering replacement parts
• Machine Model number (i.e. Model #1300) • Serial Number
• Date Purchased
• Voltage of unit (main input): 120V, 240V or 230V (overseas) - single, double, or triple input
• Main input power - single phase (1O)
• Cycle: 50 or 60 hz. (U.S. and North American models are 60 hz.)
(Most overseas units are 50 hz. Check invoice for correct cycle.)
• Blowers: two or four
If this information is not known, contact supplier with serial number of machine. This information is needed on
mechanical parts as well as electrical components. (Due to mechanical adjustments that compensate for
electrical requirements, the above information is needed.)
SPARE PARTS LIST
PAR T DESCRIPTION QUANTITY
NUMBER REQUIRED
250503-8 AGITATOR BEARINGS 4
250503-7 AGITATOR BEARING FELT SEALS 4
517-6 AIRLOCK BEARINGS 2
517-7 AIRLOCK BEARING FELT SEALS 2
209031-8M-2PLYF AIRLOCK SEALS 6
426-6 SHREDDER BEARINGS 4
426-7 SHREDDER BEARING FELT SEALS 4
411-A BLOWER FILTER (2 BLOWERS) 1
13-12 BLOWER FILTER (4 BLOWERS) 1
190 #50 MASTER LINK 1
150526 #50 HALF LINK 3
2300MK 2300 MAINTENANCE KIT 1
The following is a recommended spare parts list. To keep your machine up and running, these are the
parts we suggest you keep on hand for your Model #2300 Krendl Machine.
To Next Page
Loading...