Krups BeerTender User Manual (English)

Other manuals for Krups BeerTender

Questions and Answers:

L
lfranklinAug 20, 2025
Why does my Krups Kitchen Appliances BeerTender produce too much foam?
- G
  gschneiderAug 21, 2025
  Excessive foam when dispensing beer from your Krups BeerTender can occur for several reasons: * The keg may not be cold enough. Allow the keg to cool until the temperature indicator shows it's ready. * The keg might have been shaken. If so, wait approximately 4 hours before dispensing. * You might be pulling the tap handle too slowly. Pull the handle down and forward firmly and quickly.
M
Michael JensenAug 22, 2025
What to do if my Krups Kitchen Appliances BeerTender is dispensing warm beer?
- L
  Leslie TurnerAug 22, 2025
  If your Krups BeerTender is dispensing warm beer, the keg likely hasn't been chilled sufficiently. Allow the keg to cool in the refrigerator for about 12 hours to reach the proper serving temperature.
J
Jason WilliamsAug 25, 2025
What to do if no beer is being dispensed from my Krups Kitchen Appliances BeerTender?
- N
  Noah StewartAug 25, 2025
  If no beer is coming out of your Krups BeerTender, the keg is likely empty. The last level of the volume indicator will be blinking. Replace the empty keg with a new one.
V
vwellsAug 26, 2025
Why won't my Krups BeerTender turn on?
- X
  xfrenchAug 27, 2025
  If your Krups kitchen appliance isn't turning on, ensure it is properly connected to the mains power supply. If it is not connected, connect the appliance to the power supply.
M
Michael MyersAug 27, 2025
Why is beer flowing out too slowly from my Krups Kitchen Appliances BeerTender?
- K
  Keith BrownAug 28, 2025
  If the beer is flowing too slowly from your Krups BeerTender, it's likely that the tap handle isn't fully open. Make sure to open the tap completely.
J
Janice ChapmanAug 29, 2025
What to do if the temperature indicator on my Krups Kitchen Appliances never reaches a ready-to-drink level?
- M
  Mrs. Emily SerranoAug 29, 2025
  If the temperature indicator on your Krups BeerTender never reaches the ready-to-drink level, the appliance might be exposed to excessive heat or direct sunlight. Use the appliance indoors and ensure the ambient temperature does not exceed 30°C.
M
Michael SmithAug 31, 2025
What to do if the control display shows an increasing temperature on my Krups Kitchen Appliances BeerTender?
- N
  Nicholas VangAug 31, 2025
  If the control display of your Krups BeerTender shows an increasing temperature, it might be because a warm keg was installed in a cold appliance. Allow the system to compensate for the temperature change. The displayed temperature should start decreasing after a maximum of one hour.
A
Alexandra LivingstonSep 2, 2025
What to do if I can not close the tap cover of my Krups Kitchen Appliances BeerTender?
- C
  Connor OnealSep 2, 2025
  If you cannot close the tap cover on your Krups BeerTender, it's likely that the BeerTender Keg tap isn't inserted correctly. Remove the BeerTender Keg tap and re-fit it.
S
smithjessicaSep 3, 2025
Why can't I fit the BeerTender Keg tap in the tapping unit of my Krups Kitchen Appliances?
- N
  Nancy AndersonSep 3, 2025
  If you cannot fit the BeerTender Keg tap in the tapping unit, the BeerTender Keg tap may have been activated by hand. Put the BeerTender Keg tap back in its original position.
M
Mason HuntSep 5, 2025
Why is my Krups Kitchen Appliances BeerTender dispensing warm beer?
- G
  Gina PhillipsSep 5, 2025
  Your Krups BeerTender might be dispensing warm beer because the keg hasn't been chilled long enough in the refrigerator to reach the correct serving temperature. Allow the BeerTender Keg to cool in the refrigerator for about 12 hours. Alternatively, the beer may have been tapped before reaching the correct drinking temperature. In this case, allow the BeerTender Keg to cool long enough in the appliance.

Krups BeerTender Specifications

General

Type	Beer Dispenser
Cooling System	Thermoelectric
Capacity	5 Liters
Brand	Krups
Model	BeerTender
Category	Kitchen Appliances
Voltage	120 V
Frequency	60 Hz
Color	Black, Silver
Compatible Kegs	Heineken, Newcastle Brown Ale
Weight	13.2 pounds
Temperature Indicator	LED
Compatibility	5L Heineken DraughtKeg, 5L BeerTender Kegs
Material	Plastic