7 Operating the Pressure Booster System
28 of 48
KSB Delta Basic
1983.835/01-EN
The green SET LED (5) starts flashing to indicate that the system is ready for
operation.
Press the Start/Stop button to start the pump. The green operating status LED (2)
starts flashing at different frequencies. The closer the measured pressure to the set
pressure, the higher the flashing frequency.
When the set value is reached, the green operating status LED (2) is lit continuously.
To stop the pump press the Start/Stop button (4). The green operating status LED (2)
extinguishes.
Adjusting the pressure
A pressure gauge is fitted in the discharge line. Slightly opening one of the consumer
installations facilitates pressure adjustment.
Adjusting the pressure
▪ Start up the pump (press the Start/Stop button).
▪ If the Set LED (5) flashes, press the Plus button or Minus button until the Set LED
lights up continuously.
▪ Set the pressure by pressing the Plus button or Minus button as required.
To Next Page
Loading...
