lares 4.0 Programming manual
9 R30024.130en
•
P
r
o
g
r
a
mm
.
B
a
c
k
-
up
:
- C
r
eate new
:
backs-up any programming by saving the file on an SD card
.
- R
estore
:
any programming data saved previously will be read from the SD card and loaded into the control panel
.
•
N
e
t
w
o
r
k
i
n
g
:
network configuration menu which allows the network parameters to be read/modified
- IP Address
:
the control panel IP Address
-
S
ubn
e
t
m
a
s
k
:
subnet-mask
-
G
a
t
e
w
ay
:
IP address of
ga
t
e
w
a
y
-
D
H
C
P
s
e
r
v
e
r
:
OFF / ON
(
default
ON
)
. This menu item is activated to allow the DHCP to be re-enabled if the control panel
has been set to a
fixed IP address.
•
Language
:
select the language of the keypad form the list
.
•
Panel version
:
this allows you to view the control panel firmware version (although not the web server).
1.3.1.1 How to read the control panel IP address from keypad
If the network, where the control panel is installed, supports DHCP, to read the IP address make the following
operations:
• Step 1. make sure the control panel is connected to the network;
• Step 2. enter the installer menu by dialing the PIN code on the numeric keypad (default: 123456);
• Step 3. scroll the menu items up to "Networking" and press OK;
• Step 4. the "IP Address" is displayed, make a note and exit the menu by pressing ESC twice.
Then type the IP address in the browser address bar: <https://control-panel-IP-address>.
Note: The default address will be 192.168.2.97 in the event that the network to which the control panel is connected
does not support the DHCP,
so type <https://192.168.2.97> in the browser address bar.
NOTE 1
:
When you first switch on the keypad, the English menu will be displayed. To change the language, access the
installer menu from the keypad via the webserver.
NOTE 2
:
A
PP
K
s
e
n
i
a
P
r
o is also available
for “
l
a
r
e
s
W
L
S
96
-
I
P
” platform although not for “
l
a
r
e
s”.
NOTE 3
:
It is not possible to set a configuration if the system is armed, even partially, or if the access with installer code has
been disabled by the user.
To Next Page
Loading...
Need help?
General
