20 TROUBLESHOOTING 170
Faults Possible cause Action
The engine does not turn when the
starter button is pressed
Operating error – Carry out the start procedure. ( p. 47)
Battery is discharged –
Recharge the battery. x ( p. 128)
Fuses 1, 2, 3 are blown – Change the fuses of individual power consumers.
( p. 134)
Main fuse burned out – Change the main fuse. ( p. 131)
No ground connection present – Check the ground connection.
Engine turns only if the clutch lever is
drawn
The vehicle is in gear – Shift gear to neutral.
The vehicle is in gear and the side
stand is folded out
– Shift gear to neutral.
Engine turns but does not start. Operating error – Carry out the start procedure. ( p. 47)
Fuse 3 blown – Change the fuses of individual power consumers.
( p. 134)
Coupling of fuel hose connection not
connected
– Reconnect coupling of fuel hose connection.
Defect in fuel injection system – Read out the fault memory using the KTM diag-
nostics tool. x
Throttle opened while starting – When starting, DO NOT open the throttle
– Carry out the start procedure. ( p. 47)
Engine has too little power. Air filter is very dirty –
Remove the air filter. x ( p. 81)
–
Install the air filter. x ( p. 82)
Fuel filter is very dirty –
Check the fuel pressure. x
Defect in fuel injection system – Read out the fault memory using the KTM diag-
nostics tool. x
Map‑Select switch incorrectly adjusted – Adjust the engine characteristic. ( p. 152)
To Next Page
Loading...
Need help?
General
