KTM 2014 690 Enduro R EU User Manual

8 RIDING INSTRUCTIONS 52
– If the engine stalls (e.g. at a crossroads), just pull the clutch lever and press the elec-
tric starter button. You do not have to shift into neutral.
– Switch off the engine if you expect to be standing for a long time.
– Avoid frequent and longer slipping of the clutch. This heats the engine oil, the engine
and the cooling system.
– Ride with a lower engine speed instead of with a high engine speed and a slipping
clutch.
– If the FI warning lamp (MIL) lights up during a trip, stop immediately. When you shift to
neutral, the FI warning lamp (MIL) starts to flash.
Info
From the flashing rhythm, you can derive a two-digit number, the so-called blink
code. The blink code tells you which component has a fault.
8.5 Braking
Warning
Danger of accidents Reduced braking efficiency due to a wet or dirty brake system.
– Clean or dry a dirty or wet brake system by riding and braking gently.
Warning
Danger of accidents Reduced braking efficiency caused by spongy pressure point of front or rear brake.
– Check the brake system and do not continue riding. (Your authorized KTM workshop will be glad to help.)
Warning
Danger of accidents Failure of brake system.
– If the foot brake lever is not released, the brake linings drag continuously. The rear brake may fail due to overheating. Take your
foot off the foot brake lever when you are not braking.

KTM 2014 690 Enduro R EU Specifications

General

Bore x Stroke	102 mm x 84.5 mm
Transmission	6-speed
Front Tire	90/90-21
Rear Tire	140/80-18
Seat Height	910 mm
Starter	Electric starter
Frame	Chromium-Molybdenum steel trellis frame, powder coated
Ground Clearance	280 mm
Engine Type	Single cylinder, 4-stroke
Displacement	690 cc
Power	67 hp (49.5 kW)
Fuel System	Electronic fuel injection
Cooling System	Liquid-cooled
Front Suspension	WP USD Ø 48 mm
Rear Suspension	WP Suspension
Front Brake	Single 300 mm disc
Rear Brake	Single 240 mm disc
Fuel Capacity	12 liters
Clutch	hydraulically operated