KTM 690 Enduro R 2021 Setup Instructions

2 SETUP
6
S04681-10
– Charge the 12-V battery. ( p. 10)
– Install the 12-V battery.
–
Plug in connector
5
on the starter relay.
S04687-10
–
Remove the rear fairing. ( p. 13)
– Take off the side cover. ( p. 13)
– Remove the rear left side cover. ( p. 14)
– Remove the rear right side cover. ( p. 14)
Info
A total of four markings
6
have been added to the
underside of the rear fairing and the two side covers.
– Drill the holes for the grab handle in three steps at these
points.
Guideline
Bore diameter for the grab
handle
14.5 mm (0.571 in)
– Install the rear left side cover. ( p. 15)
– Install the rear right side cover. ( p. 15)
– Fit the rear fairing. ( p. 16)
S03412-10
–
Store tool set
7
in the tool set compartment.
– Mount side cover. ( p. 16)
S03407-01
– Mount the reflector.

KTM 690 Enduro R 2021 Specifications

General

Engine Type	Single cylinder, 4-stroke
Bore x Stroke	105 mm x 80 mm
Transmission	6-speed
Fuel System	Electronic Fuel Injection
Cooling	Liquid-cooled
Compression Ratio	12.7:1
Starter	Electric starter
Front Tire	90/90-21
Rear Tire	140/80-18
Seat Height	910 mm
Power	74 hp (55 kW) @ 8, 000 rpm
Torque	73.5 Nm
Frame	Chromoly steel trellis frame
Front Suspension	WP XPLOR USD, 48 mm
Rear Suspension	WP XPLOR monoshock
Front Brake	Single 300 mm disc
Rear Brake	Single 240 mm disc
ABS	Bosch 9.1 MP (disengageable)
Front Wheel	21 inch
Rear Wheel	18 inch
Wheelbase	1504 mm
Ground Clearance	270 mm
Fuel Tank Capacity	13.5 l
Dry Weight	146 kg