KTM 890 ADVENTURE R 2023 Setup Instructions

SETUP 2
7
I00364-10
(EU)
–
Mount reflector
3
with rubber bushings
4
and tension
washers
5
on the license plate holder
6
.
– Position the license plate bracket on the license plate sup-
port.
–
Mount and tighten screws
7
.
Guideline
Screw, license
plate holder
M5 5 Nm (3.7 lbf ft)
Loctite
®
243™
– Carefully loosen and remove the rear tension belt.
Info
An assistant prevents the motorcycle from falling over.
– Carefully loosen and remove the tension belts around the lower
triple clamp.
The vehicle is released at the front.
– Together with an assistant, take the vehicle off the pallet.
F02143-01
– Remove the seat. ( p. 9)
– Remove spare key and KEYCODECARD from under the seat and
keep in a safe place for the handover.
– Charge the 12-V battery. ( p. 16)
Guideline
The 12-V battery must be fully charged before it is handed
over to the customer.
Info
The first charging process may take longer with a new
12-V battery.
I00365-10
–
Remove protection cap
8
.
–
Plug in the plug
9
of the starter relay.
–
Mount protection cap
8
.
F03429-01
Info
The tool set can be stored in the left or right storage com-
partment.
The left storage compartment is described as an example.
– Remove the left side cover. ( p. 10)
– Open storage compartment on the left. ( p. 10)
– Store the tool set in the storage compartment.
– Close storage compartment on the left. ( p. 11)
– Install the left side cover. ( p. 11)

KTM 890 ADVENTURE R 2023 Specifications

General

Engine Type	2-cylinder, 4-stroke, parallel twin
Displacement	889 cc
Transmission	6-speed
Front Suspension	WP XPLOR-USD, Ø 48 mm
Bore x Stroke	90.7 mm x 68.8 mm
Compression Ratio	13.5:1
Fuel System	Electronic Fuel Injection
Final Drive	Chain
Front Tire	90/90-21
Rear Tire	150/70-18
Cooling	Liquid cooled
Lubrication	Forced oil lubrication with 2 oil pumps
Frame	Chromium-Molybdenum-Steel frame using the engine as stressed element, powder coated
Power	105 hp (77 kW) @ 8, 000 rpm
Torque	100 Nm
Fuel Tank Capacity	20 liters
Seat Height	880 mm (34.6 in)
Dry Weight	196 kg (432 lb)
Rear Suspension	WP XPLOR PDS shock absorber
Front Brake	2x radially mounted 4-piston calipers
Rear Brake	2-piston floating caliper
ABS	Bosch 9.1 MP (incl. Cornering-ABS and offroad mode)
Wheels Front	21"
Wheels Rear	18"
Chain	520
Steering Head Angle	63.5°
Ground Clearance	263 mm