TROUBLESHOOTING 180
Faults Possible cause Action
The ABS warning lamp lights up Large difference in wheel speeds of the
front and rear wheels
– Stop the vehicle, switch off the ignition, and
start it again.
Malfunction in ABS – Read out the ABS fault memory using the KTM
diagnostics tool. x
High oil consumption Engine oil level too high – Check the engine oil level. ( p. 165)
Engine oil too thin (low viscosity) – Change the engine oil and filter, clean the oil
screens. x ( p. 166)
The headlight and tail light are not
functioning
Fuse 2 blown – Change the fuses of individual power consumers.
( p. 130)
Turn signal, hazard warning flasher,
brake light and horn are not functional
1, or 3 fuse blown – Change the fuses of individual power consumers.
( p. 130)
Battery discharged Ignition not switched off when vehicle
was parked
–
Recharge the battery. x ( p. 125)
Battery is not charged by the alternator –
Check the charging voltage. x
Combination instrument shows nothing
in the display
Fuse 6 blown – Change the fuses of individual power consumers.
( p. 130)
To Next Page
Loading...
Need help?
General
