TUNING THE CHASSIS 80
Info
The spring preload can be adjusted correctly only if the rear wheel and the
swingarm are fully relieved of weight.
B00619-12
– Loosen retaining ring .
– Turn adjusting ring until the spring is no longer under tension.
Hook wrench (T157S)
– Measure the overall spring length without a load.
– Tension the spring by turning adjusting ring to the prescribed value.
Guideline
Spring preload
Comfort 10 mm (0.39 in)
Standard 10 mm (0.39 in)
Sport 10 mm (0.39 in)
Full payload 12 mm (0.47 in)
– Tighten retaining ring .