DIESEL ENGINE
05
SERIES
WSM,
01640
[2]
GENERAL
PRECAUTION
-0
11
179OFOO051
0
During disassembly, carefully arrange removed parts in a clean
area to prevent confusion later. Screws, bolts and nuts should
be replaced in their original position to prevent reassembly
errors.
0
When special tools are required, use KUBOTA genuine special
tools. Special tools which are not frequently used should be
make according
to
the drawings provided.
0
Before disassembling or servicing live wires, make sure
to
always disconnect the grounding cable from the battery first.
0
Remove
oil
and dirt from parts before measuring.
0
Use only KUBOTA genuine parts for parts replacement to
maintain engine performance and to ensure safety.
0
Gaskets and O-rings must be replaced during reassembly.
Apply grease to new O-rings or oil seals before assembling.
0
When reassembling external or internal snap rings, position
them
so
that the sharp edge faces against the direction from
which force is applied.
0
Be sure to perform run-in the serviced or reassembled engine.
Do not attempt to give heavy load at once, or serious damage
may result to the engine.
A
CAUTION
0
Certain components used in this engine (cylinder head-
gasket, exhaust gasket, etc.) contain asbestos. Handle with
care according
to
safety regulation.
(1)
Grease
(2)
Force
(3)
Place the Sharp Edge agalnst the
Direction
of
Force
(A)
External Snap
Ring
(6)
Internal
Snap
Ring
01
640s
10030
s-3
Redistribution or publication of this document,
by any means, is strictly prohibited.
To Next Page
Loading...
Need help?
General