12 OPERATING THE MACHINE
OPERATING THE MACHINE
OPERATING NEW MACHINE
How a new machine is operated and maintained
determines the life of the machine.
A new machine just off the factory production line has
been, of course, tested, but the various parts are not
accustomed to each other, so care should be taken to
operate the machine for the first 50 hours at a slower
speed and avoid excessive work or operation until the
various parts become "broken-in." The manner in which
the machine is handled during the "breaking-in" period
greatly affects the life of your machine. Therefore, to
obtain the maximum performance and the longest life of
the machine, it is very important to properly break-in your
machine. In handling a new machine, the following
precautions should be observed.
BChanging Lubricating Oil for New
Machines
The lubricating oil is especially important in the case of a
new machine. The various parts are not "broken-in" and
are not accustomed to each other; small metal grit may
develop during the operation of the machine; and this may
wear out or damage the parts. Therefore, care should be
taken to change the lubricating oil a little earlier than
would ordinarily be required.
For further details of change interval hours, see
"SERVICE INTERVALS" in "MAINTENANCE" section.
BEngine Break-in
After the first 50 hours of operation, change the engine oil
and filter. (See "EVERY 100 HOURS" "EVERY 200
HOURS" in "PERIODIC SERVICE" section.)
BMachine Break-in
After the first 200 hours of operation, change the
transmission fluid.
After the first 50 hours of operation, change the oil filter
cartridge. (See "EVERY 200 HOURS" in "PERIODIC
SERVICE" section.)
To avoid personal injury:
A Do not allow any person other than the driver to
ride on the machine.
A Do not drive the machine close to the edges of
ditches or banks which may collapse under the
weight of the machine, especially when the
ground is loose or wet.
A Slow down before turning.
A To avoid tip over, operate up and down slopes,
not across. Avoid sudden starts and stops on
slopes. Slow down, and use extra caution when
changing direction on a slope. Do not use the
machine on steep incline.
Park the machine on a firm, level surface.
A Watch where you are going at all times. Watch
for and avoid obstacles. Be alert at curbs, near
trees, and other obstructions and hidden
hazards.
A Do not drive a machine on streets or highways.
Watch for traffic when you cross roads or
operate near roads.
A Look to the rear before and when backing.
Make sure the area immediately behind you is
clear of obstructions or holes and small
children. Use extra caution when a machine is
equipped with Grass Catcher.
To Next Page
Loading...
