33PERIODIC SERVICE
4. If the scale forms in the tube, clean with the scale
inhibitor or its equivalent.
5. Each time the bonnet screen is covered with grass
during operation, rub it off the screen with the hand.
Check the radiator screen from time to time if grass
accumulates.
BChecking Tire Pressure
To avoid personal injury:
A Do not attempt to mount a tire on a rim. This
should be done by a qualified person with the
proper equipment.
A Always maintain the correct tire pressure.
Do not inflate tires above the recommended
pressure shown in the Operator's Manual.
A Never operate machine with a loose rim, wheel,
or axle.
Whenever bolts are loosened, retighten to
specified torque.
Check all bolts frequently and keep them
tightened.
C Inflation Pressure
Though the inflation pressure is factory-set to the
prescribed level, it naturally drops slowly in the course of
time. Thus, check it everyday and inflate as necessary.
(1) Radiator screen
(1) Bonnet screen
Tire sizes
Recommended
Inflation Max.
Pressure
Front
24 x 12 - 12,
4PR
140 kPa
(1.4 kgf/cm , 20 psi)
Rear
18 x 9.5 - 8,
4PR
200 kPa
(2.0 kgf/cm , 28 psi)
(1) Ground (A) "INSUFFICIENT"
(B) "NORMAL"
(C) "EXCESSIVE"
To Next Page
Loading...
