Kubota F2880 - LUBRICANTS, FUEL AND COOLANT

28 MAINTENANCE
LUBRICANTS, FUEL AND COOLANT
Note * Oil amount when the oil level is at the upper level of the oil level gauge.
A To prevent serious damage to hydraulic systems, use only KUBOTA genuine fluid or its equivalent.
A Engine Oil:
A Oil used in the engine should have an American Petroleum Institute (API) service classification and Proper SAE
Engine Oil according to the ambient temperatures as shown above.
Place
Capacities
Lubricants
F2880 F3680
Fuel 61 L (16.1 U.S.qts.)
No.2-D diesel fuel
No.1-D diesel fuel if temperature is
below -10 (14 )
Coolant 4.6 L (4.9 U.S.qts.)
Fresh clean water with anti-freeze
Recovery tank 0.6 L (0.6 U.S.qts.)
Engine crankcase 3.5 L (3.7 U.S.qts.)
5.0 L
(5.3 U.S.qts.)
Engine oil: API Service
Classification CD, CE or CF
Above 25 (77 )
.....SAE30, SAE10W-30 or 15W-40
0 to 25 (32 to 77 )
.........SAE20, SAE10W-30 or 15W-40
Below 0 (32 )
.......SAE10W, SAE10W-30 or 15W-40
Transmission case 14 L (14.8 U.S.qts.) KUBOTA UDT or SUPER UDT fluid*1
Rear axle
Differential case
1.5 L (1.6 U.S.qts.)
KUBOTA UDT, SUPER UDT fluid*1 or
SAE85W, SAE90 gear oil
(API service classification: more than GL-3)
Rear axle gear case
(RH & LH)
0.5 L (0.5 U.S.qts.)
Greasing
No. of greasing points
Capacity Type of grease
F2880 F3680
Speed control pedal
shaft
11
Until grease
overflows
Multipurpose EP2 Grease
(NLGI Grade No. 2)
Lift link boss (RH & LH) 2 2
Differential lock pedal
boss
11
Universal joint 1 1
Rear wheel drive shaft
(F & R)
22
Knuckle arm
(RH & LH)
22
Seat adjuster 2 2 Moderate amount Oil
HST neutral shaft 1 1
Cable (Throttle) 1 1