Kubota F2880 - Replacing Transmission Oil Filter Cartridge

PERIODIC SERVICE44
A Do not operate the machine immediately after
changing the transmission fluid.
A Run the engine at medium speed for a few minutes to
prevent damage to the transmission.
BReplacing Transmission Oil Filter
Cartridge
To avoid personal injury:
A Be sure to stop the engine and remove the key
before changing the oil filter cartridge.
A Allow transmission case to cool down
sufficiently; oil can be hot and may cause
burns.
1. The oil filter cartridge must be changed every 200
service hours.
2. Remove the oil filter cartridge by using the filter
wrench.
3. Apply a slight coat of oil onto the cartridge gasket.
4. To install the new cartridge, screw it in by hand. Over
tightening may cause deformation of the rubber
gasket.
5. After the new cartridge is replaced, the transmission
fluid level normally decreases a little. Add fluid if
necessary.
6. Check for oil leaks around the filter gasket.
A To prevent serious damage to a hydraulic system,
replace a highly efficient, 10 m filter. Use only a
genuine KUBOTA filter.
(1) Drain plug (LH)
(2) Drain plugs (Both sides)
(1) Oil filter cartridge
(1) Oil filter cartridge (A) Screw