Kubota F2880 - Storage

52 STORAGE
STORAGE
To avoid personal injury:
A To reduce fire hazards, allow the engine and
exhaust system to cool before storing the
machine in an enclosed space or near
combustible materials.
A To avoid the danger of exhaust fume
poisoning, do not operate the engine in a
closed building without proper ventilation.
A Do not clean the machine with engine running.
A To avoid fire hazards, do not leave grass and
leaves in the mower and the grass catcher. (if
equipped)
A When storing, remove the key from the key
switch to avoid operation by unauthorized
persons.
When the machine will not be operated for over two
months, clean the machine and perform the following
operations before storage.
1. Repair parts as necessary.
2. Check bolts and nuts and tighten as necessary.
3. Apply grease or engine oil to parts most likely to rust.
4. Inflate the tires to a little above the standard pressure
levels. (Approximately 110%)
5. Lower the mower to the ground.
6. Remove the battery from the machine, recharge it,
adjust the electrolyte to the proper level, and store in a
cool dry place.
The battery discharges over time even while in
storage. Recharge it once a month in hot seasons and
once every 2 months in cold seasons.
7. Drain fuel tank, fuel lines.
8. Store the machine where it is dry and sheltered from
rain. Cover the machine with a tarpaulin.
9. Moisture content in most grasses can damage the
mower and grass catcher (if equipped) if these
components are not properly cleaned after use.
Make sure the mower and the grass catcher are clean
and completely empty before storage.
10.Jack the machine up and place blocks under the front
and rear axles so that all four tires are off the ground.
Keep the tires out of direct sunlight and extreme heat.
A When washing the machine, be sure to stop the
engine. Allow sufficient time for the engine to cool
before washing.
A Cover the machine after the muffler and the engine
have cooled down.
1. Check the tire air pressure and inflate the tires if they
are low.
2. Jack the machine up and remove the support blocks.
3. Install the battery. Before installing the battery, make
sure it is fully charged.
4. Check the fan belt tension.
5. Check all fluid levels (engine oil, transmission /
hydraulic oil, engine coolant and any attached
implements).
6. Start the engine. Observe all gauges. If all gauges are
functioning properly and reading normal, move the
machine outside.
7. Once outside, park the machine and let the engine idle
for at least five minutes.
8. Shut the engine off and walk around machine and
make a visual inspection looking for evidence of oil
water leaks.
9. With the engine fully warmed up, release the parking
brake and test the brakes for proper adjustment as you
move forward. Adjust the brakes as necessary.
REMOVING THE MOWER FROM STORAGE