PERIODIC SERVICE34
BChecking Transmission Fluid Level
1. Park the machine on a flat surface, lower the
implement to the ground, shut off the engine and
remove the key.
2. To check the oil level, draw out the dipstick, wipe it
clean, replace it, and draw it out again. Check to see
that the oil level lies between the two notches.
If the level is too low, add new oil to the prescribed
level at the oil inlet.
(See "LUBRICANTS, FUEL AND COOLANT" in
"MAINTENANCE" section.)
A If oil level is low, do not run the engine.
BChecking Coolant Level
To avoid personal injury:
A Do not remove the radiator cap when the
engine is hot. Loosen cap slightly, to the stop,
to relieve any excess pressure before removing
cap completely.
Check the coolant level daily both the radiator and the
recovery tank before starting engine.
1. Remove the radiator cap and check to see that the
coolant level is just below the fill port.
2. Check to see that the coolant level is between the
"FULL" and "LOW" marks of recovery tank.
3. When the coolant level drops due to evaporation, add
water only up to just below the fill port of the radiator
and the full level of the recovery tank.
In case of leakage, add anti-freeze and water in the
specified mixing ratio up to the full level.
(See "Flush Cooling System and Changing Coolant" in
"EVERY 1 YEAR" in "PERIODIC SERVICE" section.)
(1) Oil level dipstick
(2) Oil inlet
(A) Oil level is acceptable
within this range.
(1) Radiator cap
(2) Over flow pipe
(1) Recovery tank cap
(2) Recovery tank
(A) "FULL"
(B) "LOW"
To Next Page
