Kubota F2880 - Tire and Wheels and Ballast; Tires; Inflation Pressure; Wheels

23TIRE AND WHEELS AND BALLAST
TIRE AND WHEELS AND BALLAST
TIRES
To avoid personal injury:
A Do not attempt to mount a tire on a rim. This
should be done by a qualified person with the
proper equipment.
A Always maintain the correct tire pressure.
Do not inflate tires above the recommended
pressure shown in the Operator's Manual.
To avoid personal injury:
Never operate the machine with a loose rim, wheel,
or axle.
A Whenever bolts are loosened, retighten to
specified torque.
A Check all bolts frequently and keep them
tightened.
BInflation Pressure
Though the inflation pressure is factory-set to the
prescribed level, it naturally drops slowly in the course of
time. Thus, check it everyday and inflate as necessary.
WHEELS
A Follow the same checking procedure when the
machine is first used.
BFront Wheels (Drive Wheels)
Tire sizes
Recommended
Inflation Max.
Pressure
Front
24 x 12 - 12,
4PR
140 kPa
(1.4 kgf/cm , 20 psi)
Rear
18 x 9.5 - 8,
4PR
200 kPa
(2.0 kgf/cm , 28 psi)
(1) Ground (A) "INSUFFICIENT"
(B) "NORMAL"
(C) "EXCESSIVE"