Kubota F2880 - Cleaning Air Cleaner Element

PERIODIC SERVICE36
BCleaning Air Cleaner Element
1. Remove the element.
2. Clean the element:
(1) When dry dust adheres to the element, blow
compressed air from the inside turning the
element. Pressure of compressed air must be
under 205kPa (2.1kgf/cm , 30psi).
(2) When carbon or oil adheres to the element, soak
the element in detergent for 15 minutes, and then
wash it several times in water, rinse with clean
water and dry it naturally.
(3) After element is fully dried, inspect the inside of
the element with a light and check if it is damaged
or not. (referring to the instructions on the label
attached to the case.)
3. Replace the air cleaner element if:
Once yearly or after every sixth cleaning, whichever
comes first.
[F2880]
[F3680]
A The air cleaner uses a dry element. Never apply oil.
A Do not run the engine with the filter element removed.
A Be sure to refit the dust cup with the arrow (on the
rear) upright. If the dust cup is improperly fitted, dust
passes by the baffle and directly adheres to the
element.
(1) Cover
(2) Element
(3) Evacuator valve
(1) Cover
(2) Element
(3) Evacuator valve