42 PERIODIC SERVICE
.Checking
Tire Pressure
A WARNING
To avoid personal
injury:
• Do
not
attempt
to
mount
a
tire
on
a rim. This
should
be
done
by
a qualified person
with
the
proper
equipment.
•
Always
maintain the
correct
tire
pressure.
Do
not
inflate
tires
above the recommended
pressure
shown
in
the Operator's Manual.
• Inflation pressure
in
front
tires rises
quickly
when
using
compressed air.
A CAUTION
Never operate machine
with
a
loose
rim, wheel,
or
axle.
•
Whenever
bolts
are loosened, retighten
to
specified torque.
• Check all
bolts
frequently
and keep them
tightened.
• Inflation Pressure
Though the inflation pressure
is
factory-set to the
prescribed
level, it naturally drops slowly
in
the course
of
time. Thus, check it everyday and inflate as necessary.
Tire sizes
Front
16 x 6.50 -
8,
4PR
Rear
23 x
10.50 -
12,
4PR
1
BDABARAPOO2A
(1) Ground
Recommended Inflation
Max. Pressure
200 kPa
(2.0 kgf/cm', 29 psi)
140 kPa
(1.4 kgf/cm',
20 psi)
(A) "INSUFFICIENT"
(B) "NORMAL"
(C) "EXCESSIVE"
.Checking
Transmission Fluid Level
1.
Park the machine
on
a flat surface, lower the
implement to the ground, shut off engine and remove
the key.
2.
Raise the operator's seat.
3.
To check the oil level, draw out the dipstick, wipe it
clean, replace
it,
and draw it out again. Check to see
that the
oil level lies between the two notches.
If the level is too low, add new oil to the prescribed
level at the oil inlet.
(See "LUBRICANTS"
in
"MAINTENANCE" section.)
1 BDAHADAP065A
(1) Oil level dipstick
NOTE:
(A) Oil level is acceptable
within this range.
• Check the oil level
of
the transmission case with the
mower
lifted
up.
IMPORTANT:
• If oil level
is low, do not
run
engine.