116 LIST OF SCREENS
*1 PM control diagnosis
*2 NOx control diagnosis
45
Overheat advance
warning
Auto idling for
hydraulic oil
temperature rising
The engine was forced to get
idling because the hydraulic
oil temperature had risen too
high.
Leave the engine idling until
this warning disappears.
Do not stop the engine
because the hydraulic oil
temperature will increase
sharply.
Be sure to cool down the
engine without stopping it.
Unclog the oil cooler and
other components before
using again.
Check also the hydraulic
system for oil leak and other
troubles.
If an oil leak is found,
immediately contact your
local dealer for repair.
46
Fuel got mixed with
water
Water is in the fuel filter and
the water separator may be
full with water.
If you don’t drain the fuel
filter immediately after the
alarm, the engine may be
seriously damaged.
Immediately drain the fuel
filter after stopping the
engine and drain the water
separator as soon as
possible.
47
Engine system error
Engine system is in trouble.
Engine system does not
function normally.
Immediately contact your
local dealer.
Press the switch4.
PCD*1 system is failured.
PCD system must be
repaired.
Immediately contact your
local dealer.
Press the switch4.
NCD*2 system is failured.
NCD system must be
repaired.
Immediately contact your
local dealer.
No.
Message
Problem or failure
(What happened)
Machine behavior
(Provisional measure)
Correction
To Next Page
Loading...
