71MAINTENANCE
BGreasing Bucket Pin and Bucket Link Pin/
Angle Pin and Angle Cylinder Boss
To avoid personal injury or death:
A First lower all attachments on the ground then
stop the engine and remove the key.
A While greasing, take care not to step on the
bucket teeth.
A When doing excavation work in water, generously
grease the following points. After ending work, grease
again.
Grease the marked grease fittings shown by arrows in the
illustration below.
BCleaning Evacuator Valve
Open the evacuator valve to get rid of large particles of
dust and dirt.
BChecking Diesel Particulate Filter (DPF)
Muffler
To avoid personal injury or death:
A Before checking or cleaning the DPF muffler,
stop the engine and wait long enough until it is
cooled down.
Check to see if nothing flammable is deposited around the
DPF muffler. Otherwise a fire may result.
(1) Bucket link pin
(2) Fixing pin between arm and bucket
(1) Angle pin
(2) Angle cylinder boss
(1) Evacuator valve
(1) DPF muffler
To Next Page
Loading...
