118 LIST OF SCREENS
A Stopping the engine or pressing the inhibit switch while automatic regeneration, automatic regeneration will be stopped.
After restarting the engine, automatic regeneration starts.
A Regeneration time is approximately 20 to 30 minutes, and the interval is approximately 20 to 30 hours. But actual
regeneration time and interval depend on usage environment like ambient temperature, exhaust temperature and
engine speed.
A When the interval of DPF regeneration has become 5hours or shorter routinely, change the oil for new one, if this
condition continues even after an oil change, consult your local KUBOTA dealer.
Warning lamp Display Meaning Required operator action
Blinking
(yellow)
When the message "Now HP is limited." appears on the
display, the DPF is clogged. To protect the DPF, the engine
output is limited.
Consult your KUBOTA local dealer.
Blinking
(red)
DPF must be repaired.
To protect the DPF, the engine output is limited.
When the pilot control lock lever is pulled up, the engine will
stop after 60 seconds in order to protect DPF.
When the pilot control lock lever is down, the engine will not
stop while the engine output is limited.
Immediately contact your local
dealer.
(Refer to No. 41 in "NAVIGATION
LIST OF SCREENS" section.)
Blinking
(red)
Exchange the DPF.
To protect the DPF, the engine output is limited.
Immediately contact your local
dealer.
(Refer to No. 42 in "NAVIGATION
LIST OF SCREENS" section.)
To Next Page
Loading...
