PERIODIC SERVICE130
BAdjusting Front Axle Pivot
If the front axle pivot pin adjustment is not correct, front
wheel vibration can occur causing vibration in the steering
wheel.
C Adjusting procedure
Loosen the lock nut, screw-in the adjusting screw until
seated, then tighten the screw with an additional 1/6 turn.
Re-tighten the lock nut.
BAdjusting King-pin Pivot
Loosen the lock nut and tighten the adjusting screw with
following torque:
EVERY 800 HOURS
BReplacing Fuel Filter
[M126GX, M135GX]
1. Remove the fuel filter.
2. Put a film of clean fuel on rubber seal of new filter.
3. Tighten the filter quickly until it contacts the mounting
surface.
Tighten filter by hand an additional 1/2 turn only.
4. Bleed the fuel system.
(See "Bleeding Fuel System" in "SERVICE AS
REQUIRED" in "PERIODIC SERVICE" section.)
BAdjusting Engine Valve Clearance
Consult your local KUBOTA Dealer for this service.
EVERY 1500 HOURS
BCleaning Fuel Injector Nozzle Tip
Consult your local KUBOTA Dealer for this service.
BChecking and Cleaning EGR Cooler
Consult your local KUBOTA Dealer for this service.
BChecking Accumulator
[Front suspension type]
Consult your local KUBOTA Dealer for this service.
EVERY 3000 HOURS
BChecking Turbocharger
Consult your local KUBOTA Dealer for this service.
BChecking Supply Pump
Consult your local KUBOTA Dealer for this service.
(1) Adjusting screw
(2) Lock nut
Adjusting screw 4.9 to 9.8 N-m, 0.5 to 1.0 kgf-m
Lock nut 98.1 to 147 N-m, 10 to 15 kgf-m
(1) Adjusting screw
(2) Lock nut
(1) Fuel filter
To Next Page
Loading...
Need help?
General
