23OPERATING THE ENGINE
When the Rev-limiter control dial is set, the engine speed
will not exceed the speed that is set. Even when the hand
throttle lever is operated. Turn the dial all the way to the
right to the " " position.
5. Place the PTO clutch control switch in
"OFF" position.
(1) PTO clutch control switch "ON" (Engaged)
"OFF" (Disengaged)
(A) "PUSH"
6. Set the throttle lever at the minimum
speed position.
(1)
(2)
Hand throttle lever
Rev-limiter control dial
"INCREASE"
"DECREASE"
7. Insert the key into the key switch and
turn it "ON".
"OFF" (Engine-Stop)
"ACC" (Electrical
Power-accessories)
"ON" (Engine-Run)
"START" (Engine-Start)
NOTE:
ACC... A All the accessories can be used while the
engine is stopped.
A Do not leave the key at "ACC" position. The
battery will be quickly discharged. Turn it
back to "OFF" after use.
To Next Page
Loading...
Need help?
General
