OPERATING THE ENGINE18
STOPPING THE ENGINE
1. After idling the engine, turn the key switch to
"OFF" position.
2. Remove the key.
3. Do not leave the key switch "ON" (key in the "ON"
position) as the battery will discharge when the
engine is not running.
4. Apply the parking brake.
5. Turn the fuel valve to the "OFF" position.
Fuel valve position
BEngine Stop Lever (Inside the Hood)
The engine stops when the key switch is turned "OFF". If
the engine does not stop, make sure the motion control
levers are in the "NEUTRAL LOCK" position, the PTO
lever is "OFF", the mower lowered to the ground and
apply the parking brake, then carefully get off the
machine. Then open the hood and pull engine stop lever
(Red mark) and hold it until the engine stops. Then
contact your local KUBOTA Dealer immediately.
To avoid personal injury:
A Do not operate the machine until the engine
stop system is repaired.
(1) Fuel valve (A) "OFF"
(B) RH (Primary tank)
(C) LH (Secondary tank)
Rightward OFF
Downward RH (Primary tank)
Leftward LH (Secondary tank)
(1) Engine stop lever
To Next Page
Loading...
